Install MPFS in Ubuntu Server riscv64+icicle in Jammy Daily (archived)

DownloadLink to the download information
Install MPFSDetailed information on the testcase
Testcase (Report an issue with this testcase)

The scope of this test is to ensure that riscv64+icicle image boots from SD card on Microchip Polarfire Icicle board

Flash downloaded image onto SD card
You can use Gnome Disks app to restore img.xz onto the SD card
Alternatively you can use xz -d to decompress, and then dd to copy the image to the SD card
Connect networking, serial console to the board
Ethernet cable for networking (both Ethernet connectors work)
USB cable for serial console (board layout here: https://www.microchip.com/content/dam/mchp/documents/FPGA/ProductDocumen... page 6)
Connect to the 'firmware' serial console
sudo screen /dev/ttyUSB0 115200
Connect to the 'kernel' serial console
sudo screen /dev/ttyUSB1 115200
Power on the board
You should see U-BOOT menu on the firmware console
It should then boot GRUB after a delay
You should see GRUB menu
It should then boot the default kernel after a delay on the kernel serial console
After a while cloud-init will run
Then one will be able to login
Login and change password
Login using ubuntu for both username and password
Reenter ubuntu password again
Set new password
Confirm the new password
Perform generic testing
Check that apt update works
Run any command that is not installed, check that command-not-found recommends things to install
e.g. hello
Install a package and check that it works, e.g. hello
Perform snap testing
Install a snap and check that it works, e.g. hello
Reboot
The board should reboot normally
Poweroff
Console messages should reach poweroff target
There should be final kernel dmsg powering off
Manually turn power-off from the board

If all actions produce the expected results listed, please submit a 'passed' result.
If an action fails, or produces an unexpected result, please submit a 'failed' result and file a bug. Please be sure to include the bug number when you submit your result.

ReporterLast updateBugsComment
Add a test result

You need to be logged in to submit your test results.