Notice board

WARNING: This image is OVERSIZED. This should never happen during milestone testing.

1821_Install PIC64GX1000 Curiosity Kit in Ubuntu Server powerpc in Xenial Beta 2 (archived)

DownloadLink to the download information
1821_Install PIC64GX1000 Curiosity KitDetailed information on the testcase
Testcase (Report an issue with this testcase)

The scope of this test is to ensure that riscv64+pic64gx image boots from
SD card on the Microchip PIX64GX1000 Curiosity Kit

Flash the downloaded image onto a microSDXC card
You can use xz -d to decompress, and then dd to copy the image to the SD card
Connect network
Connect Ethernet to the RJ45 connector
Connect UART
Connect with a USB cable to the USB-C socket for the serial console
The board is powered via the same USB cable if jumper J47 is closed.
Connect to the serial console
sudo screen /dev/ttyUSB0 115200,cs8,-parenb,-cstopb
The U-Boot's 'Hit any key to stop autoboot:' message is displayed.
The board launches GRUB after the count-down.
You should see GRUB menu
The default kernel should boot after a delay
After a while cloud-init will run
On first boot wait for the 'Cloud-init finished' message.
Login and change password
Login using ubuntu for both username and password
Reenter the password again
Set a new password
Confirm the new password
Perform generic testing
Check that apt update works
Run any command that is not installed, check that command-not-found recommends things to install
e.g. hello
Install a package and check that it works, e.g. hello
Perform snap testing
Install a snap and check that it works, e.g. hello
Reboot
The board should reboot normally
Poweroff
Console messages should reach poweroff target
There should be final kernel powering off message
Disconnect the USB-C cable to power off the board

If all actions produce the expected results listed, please submit a 'passed' result.
If an action fails, or produces an unexpected result, please submit a 'failed' result and file a bug. Please be sure to include the bug number when you submit your result.

ReporterLast updateBugsComment
Add a test result

You need to be logged in to submit your test results.