| Text | The scope of this test is to ensure that riscv64+icicle image boots from SD card on Microchip Polarfire Icicle board
- Flash downloaded image onto SD card
- You can use Gnome Disks app to restore img.xz onto the SD card
- Alternatively you can use xz -d to decompress, and then dd to copy the image to the SD card
- Connect networking, serial console to the board
- Ethernet cable for networking (both Ethernet connectors work)
- USB cable for serial console (board layout here: https://www.microchip.com/content/dam/mchp/documents/FPGA/ProductDocumen... page 6)
- Connect to the 'firmware' serial console
- sudo screen /dev/ttyUSB0 115200
- Connect to the 'kernel' serial console
- sudo screen /dev/ttyUSB1 115200
- Power on the board
- You should see U-BOOT menu on the firmware console
- It should then boot GRUB after a delay
- You should see GRUB menu
- It should then boot the default kernel after a delay on the kernel serial console
- After a while cloud-init will run
- Then one will be able to login
- Login and change password
- Login using ubuntu for both username and password
- Reenter ubuntu password again
- Set new password
- Confirm the new password
- Perform generic testing
- Check that apt update works
- Run any command that is not installed, check that command-not-found recommends things to install
- e.g. hello
- Install a package and check that it works, e.g. hello
- Perform snap testing
- Install a snap and check that it works, e.g. hello
- Reboot
- The board should reboot normally
- Poweroff
- Console messages should reach poweroff target
- There should be final kernel dmsg powering off
- Manually turn power-off from the board
If all actions produce the expected results listed, please submit a 'passed' result.
If an action fails, or produces an unexpected result, please submit a 'failed' result and file a bug. Please be sure to include the bug number when you submit your result.
|
